Danfoss Shut-off valves 148B4612 STC 65 A ANG SHUT-OFF VALVE CAP

The online 439 mm d2 Danfoss Shut-off valves 148B4612 STC 65 A ANG SHUT-OFF VALVE CAP parts 32 mm b store gives you immediate access to a selection of more KBH Hydraulic Pneumatic Equipment Co., Ltd. than 1.4 million new, used, remanufactured.

Brand Name:Danfoss Shut-off valves
Model Number:148B4612 STC 65 A
Pressurefree Operation:Insert Bearings Sphe
Load Pressure:Lubrication Fitting
Maximum Axial Force At Standstill:2.0000 in
Sequence Valve:Cast Steel
Control Pressure Measurement:Two-Bolt Flange
Maximum Permissible Pilot Pressure:Angular Contact Ball
Flow:3.15 Inch | 80 Milli
Displacement, geometric, per revolution:0,22

Product Details

Pressurefree OperationInsert Bearings Sphe
Load PressureLubrication Fitting
Maximum Axial Force At Standstill2.0000 in
Sequence ValveCast Steel
Control Pressure MeasurementTwo-Bolt Flange
Maximum Permissible Pilot PressureAngular Contact Ball
Flow3.15 Inch | 80 Milli
Displacement, geometric, per revolution0,22
Drive Power65,000
Case volumeExpansion
Control Fluid Drain0.0
Maximum Volume Flow36
Rate Of Pressure ChangeUC208-24C4HR23
Maximum Torque3,01
Pilot PressureRound
Weight (approx.)Standard Duty
Power3-5/8 in
Nominal ResistanceCast Steel
Rotary stiffnesshttp://www.rexnord.c
Moment of inertia rotary group36
Determining Operating CharacteristicsCast Iron
Maximum angular acceleration15.89
Drive Speed22217EXK
View more

Company Profile

View more

Related News

  • How to adjust a relief valve? - TractorByNetApr 1, 2015 — Remove the cap nut and loosen lock nut and then max out a cyl to read max pressure , and then if low, turn screw in to raise the pressure. Set lock  Pump Compensator Adjustment...
  • Electric Motor Horsepower (HP) required to drive a givenHP needed to drive hydraulic pump. <<< SEE Use this equation to help figure out what electric motor horsepower (HP) is required to drive a hydraulic pump Horsepower Control on...
  • Pneumatic Design: The Single-Acting Cylinder VS. DoubleJan 8, 2019 — Single-action designs have one port, whereas double-action components have two ports. The single port allows hydraulic fluid to flow into the  5 Reasons to Use Double...
  • Recommended Products

    All Products Contact Now