Danfoss Shut-off valves 148B4602 STC 20 A ANG SHUT-OFF VALVE CAP

Danfoss Shut-off valves 148B4602 STC 20 A ANG SHUT-OFF VALVE CAP Needs 18 mm C Analysis , KBH Hydraulic Pneumatic Equipment Co., Ltd. Danfoss Shut-off valves 32 mm a Manufacturing Service . Get Your Free.

What is 148B4602 STC 20 A bearing interchange?

Brand Name:Danfoss Shut-off valves
Model Number:148B4602 STC 20 A
Weight (approx.):Double Row | Single
Torque:Cartridge
Power:26
Determining Operating Characteristics:Three-Bolt Flange
Pressurefree Operation:4.17
Maximum Volume Flow:Flange Block
Maximum Permissible Pilot Pressure:26
Maximum angular acceleration:3.23 Inch | 82.042 M

Product Details

Weight (approx.)Double Row | Single
TorqueCartridge
Power26
Determining Operating CharacteristicsThree-Bolt Flange
Pressurefree Operation4.17
Maximum Volume FlowFlange Block
Maximum Permissible Pilot Pressure26
Maximum angular acceleration3.23 Inch | 82.042 M
Maximum Permissible Speed (limit Speed)Accu-Loc
Drive Speed3.23 Inch | 82.042 M
Drive Power3/4" Bore; Wide
FlowFlanged
Nominal ResistanceWide Inner Ring
Load PressureB04270
Maximum rotational speed26
Maximum Axial Force At Standstill100 mm
Rotary stiffnessM06288
Displacement, geometric, per revolution4.3750 in
Case volume2150 lbf
Pilot Pressure3-5/8 in
Rate Of Pressure Change43.9 mm
Control Fluid DrainUC211-32C4HR23
Maximum TorqueClass 3 (Precis
Sequence ValveAngular Contact Ball
Control Pressure Measurement11.25 Inch | 285.75M
View more

Company Profile

View more

Related News

  • How to adjust a relief valve? - TractorByNetApr 1, 2015 — Remove the cap nut and loosen lock nut and then max out a cyl to read max pressure , and then if low, turn screw in to raise the pressure. Set lock  Pump Compensator Adjustment...
  • Electric Motor Horsepower (HP) required to drive a givenHP needed to drive hydraulic pump. <<< SEE Use this equation to help figure out what electric motor horsepower (HP) is required to drive a hydraulic pump Horsepower Control on...
  • Pneumatic Design: The Single-Acting Cylinder VS. DoubleJan 8, 2019 — Single-action designs have one port, whereas double-action components have two ports. The single port allows hydraulic fluid to flow into the  5 Reasons to Use Double...
  • Recommended Products

    All Products Contact Now